This alloy has been designed as a companion alloy to our S1-e to be used in the centrifugal casting process to be cast into SILICONE RUBBER MOLDS where the cost of the die casting process is not justified and the strength and the somewhat higher cost factor of our S1-e must be considered.

(This is a restricted metal designed for industrial applications only!  Please read the MSDS (Material Safety Data Sheet) for more details!)

SPECIFICATIONS

DENSITY: 24 lbs./cu.in.

ELONGATION: 8%

LIQUIDUS TEMPERATURE: 734 F

POURING TEMPERATURE: 850 F - 950 F

TENSILE STRENGTH: 52,000

COMPRESSIVE STRENGTH: 93,000 psi

IMPACT VALUE: 35 ft.-lbs.

ELECTRICAL CONDUCTIVITY: 25% IACS

SOLDERABILITY: Can be soldered with special solders or special preparation - contact our technical department with your specific problem.

FINISHES: Mechanical, chemical, organic, electrodeposited and plastic.